Savings. Shopping.

Get Checkmate

Parts Sweden Car Power Station Exhaust Flame Thrower Kit Car Ignition Limiter Control Fire Controlle

Shop at Walmart

Walmart Parts Sweden Car Power Station Exhaust Flame Thrower Kit Car Ignition Limiter Control Fire Controlle

17.79 USD

25 promo codes

For : 13B,13B-REW, B6-ZE, AND , 13BT 6.Wire Condition: 1. When the power of the ignition coil is cut off, the "Computer Fault Light" cannot be illuminated. 8.Electric drill Battery: 18650-3.7 V (not included) Due to the different screen and different light, the image may not reflect the actual Color of the object. Thanks for your understanding. 2.Frequency table 6. Is the ignition spacing on the igniter too large or too small <2mm> 3.Soldering Item size: 260x180mm 1. Direct ignition 5. Is there any damage to the wires from the rear of the car to the igniter? 1.It should be known that the signal line of the is positive or negative, and most of the vehicles are negative. 3.The positive and negative power of the should be connected to the color of the fire-breathing control box. special attention to the wiring. 4. When the wiring is installed, the positive and negative power should be paid special attention. The connection error may burn the driving computer. 2. When the fuel injection nozzle is installed, the positive and negative power should be paid special attention. The connection error may the driving computer. 3. Does the rear tester plug have power, including positive and ground? Charging:USB 1. Is the wire connector of the fire-breathing control box peeled off or badly contacted? For : CA18, SR18, CG13/10DE, SR20, RB20, RB25, RB26, VQ20/25/30, VG30, all and . 4.Scissors Power: 0.3-1.2 W 1 x Exhaust Flame Thrower Kit Direct ignition installation precautions 7. Is there any misconnection of the fuel line of the ? Is the positive and negative wires of the ignition coil in the electric disc disconnected by the ignition head to cause an open circuit? Please allow 1-3 cm differs due to manual measurement. Material: ABS,silicone Installation: neckband, portable For : EJ20, All engines Hour of use: 6 to 12 hours Color: black/white//blue/green For MITSUBUSHI: 4G63, 4G93, 4G92, 6A12, 6A13, 6G72, 2.How to know which one of the two lines of the nozzle connector is the signal line, first unplug the plug and then use the three meter to measure the positive and negative poles of the two wires, such as one positive power and one no power supply. The power supply should be the signal line. The other method is to use the frequency meter to measure the two wires of the circuit. The frequency is the signal line. 5. screwdriver Package list: 1x portable fan 4. The fire-breathing dragon control box is connected to the wire of the rear ear of the car, with or without damage. 1. Three electric meter 5. The "igniter" in this product should be locked at the end of the exhaust pipe about one centimeter from the . At the lowest end, the ignition spacing should be controlled at 2mm. 2. Is the fire damaged , and the plug of the is dropped? installation method 7.Needle nose pliers 2. Distribute the electric panel to any car. Please note that when installing this product, the of the exhaust pipe tail should not be too small. 3.It is recommended to use the tail exhaust pipe with a diameter of more than 5 cm, or an exhaust tail pipe. 4. The “Core” in this product is installed at the bottom of the rear luggage compartment, close to the spare tire, and must be securely fixed. For : 4AGE, 4AGZE, 4, 2EET, 4EFTE, 3SGTE, 3SGE, 1ZZFE, 2ZZFE, 1GGTE, IJZGTE, 2JZGTE, 7MGT 3. The line should pass through the fire wall to the wire from being crushed and , resulting in a short circuit. Parts Runner Shirt