Need more ground light for the DJI Neo to be able to fly in lower light conditions? This 3D printed PETG bottom mount will allow the installation of a Firehouse ARC V, ARC V Pro, Micro or Micro Pro strobe light (strobe lights are not included). Simply insert the strobe light into the mount and clip it on to the bottom of the Neo. Insert the front clips first followed by the back clip. To remove, gently pry back the rear clip and rotate downward, then slide the front clips forward to remove the mount. Pairs well with our TOP STROBE MOUNT here:
https://www.etsy.com/listing/1816031560
Or our RovyVon Flashlight Mount here:
https://www.etsy.com/listing/1832216459
The DJI Neo and strobe light shown in the photos are not included, this listing is for the 3D printed mount only.
INSTALLATION INSTRUCTIONS:
Simply insert the strobe light into the mount and clip it on to the bottom of the Neo. Insert the front clips first followed by the back clip. To remove, gently pry back the rear clip and rotate downward, then slide the front clips forward to remove the mount.
PLEASE NOTE:
DO NOT fly the Neo at night with any type of payload without a remote control. Do not fly the Neo at night without a remote control, this is important, the Neo is not designed to be able to fly autonomously at night without a remote. Be sure to thoroughly test in an open area at close range prior to serious use.
**Disclaimer - Aerial-Pixel will not be held responsible for the use and/or misuse of this product. Any damages to equipment or bodily damage are solely the responsibility of the purchaser.**
Save on DJI Neo Bottom Strobe Light Mount for Firehouse Technology ARC V, ARC V Pro, Micro and Micro Pro (Strobe Not Included) with a Etsy promo code