Each hexagon is 2 inch wide.
30 per sheet - 11.5" x 11.5" sheet
You create your own design
Vinyl Brands:
Solid colors: Oracle 651 or TeckWrap
Color changing/chrome colors: Teck Wrap
Installation: There are 3 pieces to every decal, Transfer tape, decal, and paper backing you do not need to cut out your decals.
*Notes: The larger the decal/badge is, the more difficult the installation will be*
We are NOT responsible for installation errors and will NOT replace/refund the decals if you or anyone that installs them wrong.
DO NOT INSTALL THESE DECALS USING A WET SOLUTION OF WATER AND OR WATER AND SOAP!
1. Clean the badge/area thoroughly with rubbing alcohol, also wash your hands to prevent dirt and oils to contaminate the decal
2. Peel back one end of the decal and fold the paper back so that you can line up that side
3. Once happy with the alignment peel the rest of the paper backing off and work the decal down with your thumb from one side to another. Start in the middle and work your way out to the top and bottom edges.
4. After decal is fully installed, pull the application tape off slowly at a sharp angle to prevent any lifting.
5. Most bubbles will disappear after a few days in the sun, however if they do not, you can make a very small hole with a needle and work out the air(hole should close on its own after a few days in the sun.
6. If you get wrinkles, you can use very light heat from a hair dryer to work them out, however it is very easy to damage the decals using heat so be cautious.
Installation Tips:
1. Decals should be applied when the ambient temp is at 50F or higher. You can also work in a heated space to apply the decals. **Once decal is installed, weather/temp should not be impactful on the decal adhesive**
2. Most vinyl has severely reduced flexibility and generally the adhesive will freeze causing the decal to not stick or fail if temps are below 50F during installation.
3. Vinyl decals will be easier to remove when at 50F or above.
4. Do not install decals in direct sunlight.
5. Avoid water, or washing a vehicle for 24 hours after installation
6. When washing or drying a vehicle by hand use caution when wiping rags or wash mitts over vinyl decals, catching an edge could lift the decal. Do not aim pressure washer directly at decal, that can cause damage or lifting.
Save on Hexagon / Honeycomb JDM Car Decal Sticker 2 inch / Hex Side Vehicle Wrap / Truck Car SUV Decals / Fits ANY car/ Laptop/ Desktop Color addon with a Etsy discount code