Bauer Lite is an affordable and beginner friendly plastic injection mold variant of the Bauer and is intended to give a good typing experience at a low cost. A build guide and all tools necessary for the build are included. Also includes a hotswap PCB where one can test out any switches they want to try out without soldering. The keys are also easily programmable through VIA for the most efficient mapping that the user desires.   Kit Includes:  Keyboard Top Case x1 Keyboard Bottom Case x1 Plate  Hot-Swap PCB PCB Standoffs Plate Foam Rubber Feet Taco Bumpers Donut Bumpers (used with bottom case) Poron Isolation Strips (used with top case)  Screws (Torx) Torx Drivers  Tweezers  Owner's Manual Specs: Made in the USA Injection molded polycarbonate enclosure Custom 65% WKL layout w/ 0.75u WKL blockers Supports both split and full backspace 5º typing angle Isolation mounted plate Hotswap wilba.tech PCB 124.8mm Long 331.7mm Wide 29.5mm Back Height 19.8mm Front Height 5º Typing Angle   INTERNAL WEIGHT : The cast molded zinc Bauer™ Lite internal weight will give your board a boost! Simply drop it in, install two screws and enjoy an extra half pound to add some heft to your build. Plus, when paired with a translucent bottom, it’ll add a beautiful dimension to the look of your board. Includes 2 stainless steel screws 232g