All products containing batteries must be shipped by a ground shipping method. The ultimate Beginner RTF kit is here! HGLRC Draknight 2" 2S Beginner RTF Kit. This kit comes with everything you need to get up in the air the same day it arrives. It is small but mighty, powered by 2S batteries its ready for both indoor and outdoor use.  The Radio also works with various simulators so you can practice even more! Check out our other pre-built quads,  as well as our whole HGLRC product line! Features Beginner-Friendly Flight Controller Powered by 2S LiPo Batteries Complete FPV Setup 2" Compact Design Durable Build Specifications REMOTE CONTROLLER Common Operations: Frequency Pairing, Power Adjustment, Joystick Calibration Switch Design: Mix and Match (Three-Stage and Two-Stage) Model: HGLRC C1 Radio Controller w/ Dongle - ELRS Third-Party Compatibility: Receivers and Tuners USB Interfaces: USB-A, USB-C (Dual Interfaces) Radio Frequency Module: Built-in 500mW Remote Control Distance: Extended Wireless Dongle Compatibility: Yes Operation Procedures: Simplified Signal Transmission: Stable Type: Handle Control Screen: Not Required Level: Entry-Level Value: High-Value DARKNIGHT DRONE Built-in image transmission: 0-25-100-400mW (adjustable) Weight: 44.3g (excluding the weight of the receiver) Recommended propeller: Gemfan2023 propeller Flight control firmware: HGLRCF411SX1280_15A Firmware: BF HGLR-HGLRCF411SX1280_15A Built-in receiver: UART ExpressLRS 2.4G Maximum supported paddle: 2 inches ESC protocol: Dshot150/300/600 ESC firmware: Z-H-30 (Blheli_S) Master control: STM32F411 Continuous current: 12A Input voltage: 2-4S Lipo Peak current: 15A (5s) BEC output: 5V/1.5A Wheelbase: 91.8mm Specter 1003 Motor Motor: 10000KV (2s) Size: 104x104mm Type: 52 inch rack DONGLE  Built-in ELRS Maximum Supported Frequency: 250MHz External Receiver Support Protocol: CRSF Protocol ELRS Firmware Upgrade Method: Wifi or USB Plug ELRS Firmware Name: HGLRC 2.4GHz Receiving Distance: More Than 200m ELRS Firmware Version: ELRS 3.0 Size: 74x21x12.5mm Working Voltage: 5V Interface: USB-C Weight: 9.5g Includes 1x HGLRC Draknight 2" 2S Beginner RTF Kit 1x VR100 5.8GHz Analog Transmission Goggles 1x 82mm Philips 1.5 Screwdriver 1x Darknight Instruction Manual 1x 3.5mm Conversion Cable 1x M2 Hexagonal L Wrench 1x USB-C Charging Cable 1x 915MHz FPC Antenna 1x C3 Charger Manual 1x C1 Remote Control 1x 2" Darknight Drone 1x Charge Power Cord 1x Propeller Extractor 1x Wireless Dongle 1x Mirco Data Cable 2x 720mah Battery 1x C3 Charger 8x Propellers 1x Sticker 1x Case 1x Card