NOW available as a self-adhering panel backed by 3M 467MP and ready for engraving. The possibilities abound with our new White / Green / Red TriLayer Durra-Bull™ Laserable Acrylic Panels. Technical Data Sheet Exclusive to LoneStar Adhesive, this new tri-layer acrylic will open up ample opportunity to help your customers' projects stand out from the pack. Use them for custom stickers for hard hats, lunch boxes, magnets, or any other project you can't fit in a hat press! Order of colors:White (will have clear, removable film on it to prevent scratching), Green, Red Panel size:Each panel is1/16" or 1.5mm thick (minor, slight variations are normal), and APPROXIMATELY 12" x 24" (or slightly longer). The adhesive sheets are precision cut to exactly 12" x 24" and squared up with one corner of the panel, so there may be some acrylic not backed with adhesive along one or two edges.Each (12" x 24") panel will effortlessly fit 36 (2.5" x 2.5") patches. Tips: Remove the clear protective film on the FRONT of the acrylic panel before engraving. Yes, the adhesive will be bubbly on the back of the panel, as acrylic is nonporous and the functionality of the adhesive will not be affected. Clean the surface of the acrylic with soapy water and towel, or a gentle baby wipe, after engraving.  Note: These sheets are not backed by our Durra-Bull Heat Activated Adhesive, which is our industry leading thermal activated film adhesive that you all know and love. The adhesive on the self-adhering sheets is "sticky," does not need heat to apply, and may not meet the same durability standards set by Durra-Bull. It is not recommended as a replacement option for projects where you’d like the acrylic adhesion to last longer than the substrate to which it is applied.