The Tercicle Mini Quartz is a much smaller version akin to the original Terpcicle but instead makes use of a glass mouthpiece instead of a glass adapter to connect it to a rig (though these are available if you'd like to hook it up to one). These are torch heated vapes which provide an extremely pure vaporization experience and require a little practice to get the best from, though they are quite forgiving in terms of how long they can be heated for. Due to the lack of a mesh screen it's advisable to either use these with small pieces of broken up flower, packed into the chamber section, or with a coarse grind to avoid minimal feedback through the mouthpiece. We'd suggest sticking to broken up flower if possible and tamp well before inhaling if using ground. The bowl can be fully loaded (around 0.15g max) or loaded with a very small amount if desired. Though we'd always ensure there's enough packed in there so that it stays in the bowl! Loading is made easier if a SQP Mini is used, you can tamp with the included cleaning tool.  To use the Terpcicle Mini, load the chamber up as described above, with the mouthpiece section (or adapter installed, if being used with a rig) then place the Quartz heater cap on top. During heating and use, always ensure you're holding this closer to vertical than horizontal to avoid the glass joints coming apart, falling off and burning something! Heat the quartz heater cap with a large blowtorch (small single flame ones won't cut it) for 10-15 seconds, then gently inhale. It'll take a moment for the heat to soak through into the herb and chamber section, then will start to produce ample amounts of vapor. Always allow the Quartz heater to cool before putting it down or touching it... The bottom ground glass section can usually be safely held after a brief period, allowing you to remove it from there, stand it upright on a table and reload or put the device down! There is also a more thorough alternative method demonstrated by Lee from Tabletop Bongs which can be used for this and the regular Terpcicle.  The Coil Cap is now available for these setups, this is an e-nail heater setup which allows the device to be heated as a desktop vape, without the need for a torch.    From The Rogue Wax Works Based on the Vaponic design, the "Terpcicle" can deliver amazing flavor and big clouds. Go low temp and extract all those delicate terpenes. Add some heat and kick up those clouds! The Terpcicle is all glass and can be used without a screen for the purest of experiences The Terpcicle Mini uses 10mm joints. Device comes as shown in pictures 1 and 2 with long 10mm mouthpiece. We Also have available male to male adapters in 10mm -14.4mm to allow this to be connected up to a 14.4mm glass rig.    Includes Terpcicle Mini - Heater, Glass Bowl and Mouthpiece Stirring/cleaning tool (no stirring required) Made from Quartz Glass   Specifications Quartz Terpcicle Mini Heater Borosilicate Glass Bowl Borosilicate Glass Mouthpiece Up to 0.15g Capacity  Approx. 250mm Long with mouthpiece attached, approx. 95 mm long for heater and chamber 10mm Joint Size Compatible with whole flower nugs or ground material Requires a Blowtorch - We Suggest the Big Shot GT-8000 or Yocan Red Torch For Debowling the herb chamber the PortAVB is hard to beat The SQP Mini is great for loading herb in