THIS MOLLE ADAPTER IS DESIGNED TO WORK EXCLUSIVELY WITH SAFARILAND HOLSTERS If you have a Blackhawk or Blade-Tech holster, go HERE Our goal in developing the third revision of our Molle Adapter was simple: offer a low-cost, effective, and solid mount to convert the Safariland Taser 7 and Taser 10 holster to a load-bearing vest that consumes only two rows of Molle, keeps the holster tight to the chest, and retains the retention hood function. We have achieved that by creating a user-installed system that includes the most common hardware needed for quick, simple installation. If you have questions regarding the compatibility of your holster and our adapter, read the instructions or watch the video in the links below for quick answers. If you do not find the information you need, contact us. We will answer your questions as quickly as possible. Written installation instructions are HERE. Video installation instructions are HERE. The adapter WILL ALLOW CANT, however, you must remove the Molle Loks to adjust the angle. The adapter plate strength pull was tested to withstand over 100 pounds of force. (The Actual failure was around 300 pounds, which exceeded our validation capabilities.) We support law enforcement and military departments with Net 15-day terms, payable by check. Purchase Orders must be submitted from a department email, and the shipping address must match the department location exactly. A quote for bulk purchases is available if necessary. Contact us to receive a quote and initiate the order. We STRONGLY suggest using Loctite 242 or Vibra-Tite 121 or VC-3 thread locker on all screws during the final steps of the installation. Once installed with a thread locker, this system will be difficult to unassemble. Please make sure you have it dialed into your personal preference before adding the thread-locking product Terms and conditions: By purchasing this product, you take full responsibility for correctly installing the adapter to your gear. We will not be responsible for incorrect installation.